Update Arm TF references to TF-A
Update Arm Trusted Firmware references in the upstream documents to
Trusted Firmware-A (TF-A). This is for consistency with and
disambiguation from Trusted Firmware-M (TF-M).
Also update other Arm trademarks, e.g. ARM->Arm, ARMv8->Armv8-A.
Change-Id: I8bb0e18af29c6744eeea2dc6c08f2c10b20ede22
Signed-off-by: Dan Handley <dan.handley@arm.com>
Signed-off-by: David Cunado <david.cunado@arm.com>
diff --git a/docs/plat/socionext-uniphier.rst b/docs/plat/socionext-uniphier.rst
index 590ff62..37cab3b 100644
--- a/docs/plat/socionext-uniphier.rst
+++ b/docs/plat/socionext-uniphier.rst
@@ -1,19 +1,19 @@
-ARM Trusted Firmware for Socionext UniPhier SoCs
-================================================
+Trusted Firmware-A for Socionext UniPhier SoCs
+==============================================
-Socionext UniPhier ARMv8-A SoCs use ARM Trusted Firmware as the secure world
-firmware, supporting BL2 and BL31.
+Socionext UniPhier Armv8-A SoCs use Trusted Firmware-A (TF-A) as the secure
+world firmware, supporting BL2 and BL31.
UniPhier SoC family implements its internal boot ROM, which loads 64KB [1]_
image from a non-volatile storage to the on-chip SRAM, and jumps over to it.
-ARM Trusted Firmware provides a special mode, BL2-AT-EL3, which enables BL2 to
-execute at EL3. It is useful for platforms with non-TF boot ROM, like UniPhier.
-Here, a problem is BL2 does not fit in the 64KB limit if `Trusted Board Boot`_
-(TBB) is enabled. To solve this issue, Socionext provides a first stage loader
+TF-A provides a special mode, BL2-AT-EL3, which enables BL2 to execute at EL3.
+It is useful for platforms with non-TF-A boot ROM, like UniPhier. Here, a
+problem is BL2 does not fit in the 64KB limit if `Trusted Board Boot`_ (TBB)
+is enabled. To solve this issue, Socionext provides a first stage loader
called `UniPhier BL`_. This loader runs in the on-chip SRAM, initializes the
DRAM, expands BL2 there, and hands the control over to it. Therefore, all images
-of ARM Trusted Firmware run in DRAM.
+of TF-A run in DRAM.
The UniPhier platform works with/without TBB. See below for the build process
of each case. The image authentication for the UniPhier platform fully
@@ -46,7 +46,7 @@
This runs in the DRAM. It extracts more images such as BL31, BL33 (optionally
SCP_BL2, BL32 as well) from Firmware Image Package (FIP). If TBB is enabled,
- they are all authenticated by the standard mechanism of ARM Trusted Firmware.
+ they are all authenticated by the standard mechanism of TF-A.
After loading all the images, it jumps to the BL31 entry.
4. BL31, BL32, and BL33