ARM platforms: Demonstrate mem_protect from el3_runtime
Previously mem_protect used to be only supported from BL2. This is not
helpful in the case when ARM TF-A BL2 is not used. This patch demonstrates
mem_protect from el3_runtime firmware on ARM Platforms specifically
when RESET_TO_BL31 or RESET_TO_SP_MIN flag is set as BL2 may be absent
in these cases. The Non secure DRAM is dynamically mapped into EL3 mmap
tables temporarily and then the protected regions are then cleared. This
avoids the need to map the non secure DRAM permanently to BL31/sp_min.
The stack size is also increased, because DYNAMIC_XLAT_TABLES require
a bigger stack.
Change-Id: Ia44c594192ed5c5adc596c0cff2c7cc18c001fde
Signed-off-by: Roberto Vargas <roberto.vargas@arm.com>
diff --git a/plat/arm/board/common/board_css_common.c b/plat/arm/board/common/board_css_common.c
index c1c3e66..c4e83a4 100644
--- a/plat/arm/board/common/board_css_common.c
+++ b/plat/arm/board/common/board_css_common.c
@@ -1,5 +1,5 @@
/*
- * Copyright (c) 2015-2017, ARM Limited and Contributors. All rights reserved.
+ * Copyright (c) 2015-2018, ARM Limited and Contributors. All rights reserved.
*
* SPDX-License-Identifier: BSD-3-Clause
*/
@@ -73,6 +73,9 @@
const mmap_region_t plat_arm_mmap[] = {
#ifdef AARCH32
ARM_MAP_SHARED_RAM,
+#ifdef PLAT_ARM_MEM_PROT_ADDR
+ ARM_V2M_MAP_MEM_PROTECT,
+#endif
#endif
V2M_MAP_IOFPGA,
CSS_MAP_DEVICE,