refactor(measured_boot): remove passing of BL2 hash via device tree
Subsequent patches will provide a solution to do the BL2 hash measurement
and recording in BL1 itself, hence in preparation to adopt that solution
remove the logic of passing BL2 hash measurement to BL2 component
via TB_FW config.
Change-Id: Iff9b3d4c6a236a33b942898fcdf799cbab89b724
Signed-off-by: Manish V Badarkhe <Manish.Badarkhe@arm.com>
diff --git a/plat/common/plat_bl1_common.c b/plat/common/plat_bl1_common.c
index 1c6d68b..bcf9f89 100644
--- a/plat/common/plat_bl1_common.c
+++ b/plat/common/plat_bl1_common.c
@@ -1,5 +1,5 @@
/*
- * Copyright (c) 2015-2020, ARM Limited and Contributors. All rights reserved.
+ * Copyright (c) 2015-2021, Arm Limited and Contributors. All rights reserved.
*
* SPDX-License-Identifier: BSD-3-Clause
*/
@@ -27,9 +27,6 @@
#pragma weak bl1_plat_fwu_done
#pragma weak bl1_plat_handle_pre_image_load
#pragma weak bl1_plat_handle_post_image_load
-#if MEASURED_BOOT
-#pragma weak bl1_plat_set_bl2_hash
-#endif
unsigned int bl1_plat_get_next_image_id(void)
{
@@ -118,12 +115,3 @@
(void *) bl2_secram_layout);
return 0;
}
-
-#if MEASURED_BOOT
-/*
- * Calculates and writes BL2 hash data to TB_FW_CONFIG DTB.
- */
-void bl1_plat_set_bl2_hash(const image_desc_t *image_desc)
-{
-}
-#endif