diff --git a/docs/design/reset-design.rst b/docs/design/reset-design.rst
index 666ee4f..7b10c95 100644
--- a/docs/design/reset-design.rst
+++ b/docs/design/reset-design.rst
@@ -141,26 +141,19 @@
 Platform initialization
 ~~~~~~~~~~~~~~~~~~~~~~~
 
-In this configuration, when the CPU resets to BL31 there should be no parameters
-that can be passed in registers by previous boot stages. Instead, the platform
-code in BL31 needs to know, or be able to determine, the location of the BL32
-(if required) and BL33 images and provide this information in response to the
+In this configuration, when the CPU resets to BL31 there are no parameters that
+can be passed in registers by previous boot stages. Instead, the platform code
+in BL31 needs to know, or be able to determine, the location of the BL32 (if
+required) and BL33 images and provide this information in response to the
 ``bl31_plat_get_next_image_ep_info()`` function.
 
-.. note::
-   Some platforms that configure ``RESET_TO_BL31`` might still be able to
-   receive parameters in registers depending on their actual boot sequence. On
-   those occasions, and in addition to ``RESET_TO_BL31``, these platforms should
-   set ``RESET_TO_BL31_WITH_PARAMS`` to avoid the input registers from being
-   zeroed before entering BL31.
-
 Additionally, platform software is responsible for carrying out any security
 initialisation, for example programming a TrustZone address space controller.
 This might be done by the Trusted Boot Firmware or by platform code in BL31.
 
 --------------
 
-*Copyright (c) 2015-2022, Arm Limited and Contributors. All rights reserved.*
+*Copyright (c) 2015-2019, Arm Limited and Contributors. All rights reserved.*
 
 .. |Default reset code flow| image:: ../resources/diagrams/default_reset_code.png
 .. |Reset code flow with programmable reset address| image:: ../resources/diagrams/reset_code_no_boot_type_check.png
diff --git a/docs/getting_started/build-options.rst b/docs/getting_started/build-options.rst
index a285d31..490b0b3 100644
--- a/docs/getting_started/build-options.rst
+++ b/docs/getting_started/build-options.rst
@@ -742,11 +742,6 @@
    entrypoint) or 1 (CPU reset to BL31 entrypoint).
    The default value is 0.
 
--  ``RESET_TO_BL31_WITH_PARAMS``: If ``RESET_TO_BL31`` has been enabled, setting
-   this additional option guarantees that the input registers are not cleared
-   therefore allowing parameters to be passed to the BL31 entrypoint.
-   The default value is 0.
-
 -  ``RESET_TO_SP_MIN``: SP_MIN is the minimal AArch32 Secure Payload provided
    in TF-A. This flag configures SP_MIN entrypoint as the CPU reset vector
    instead of the BL1 entrypoint. It can take the value 0 (CPU reset to BL1